Euchner AS-i 3.0 Command Interface Bedienungsanleitung PDF herunterladen (Seite 94)

AS-i 3.0 Command Interface Appendix: Code description

Subject to reasonable modifications due to technical advances Id.-No.: 102875 Issue date - 3.12.2007 EUCHNER GmbH + Co. KG

Kohlhammerstraße 16, D-70771 Leinfelden-Echterdingen Tel. +49/711/7597-0, Fax +49/711/753316

6 Appendix: Code description

Table 1: Monitor state

Table 2: Colour coding

See also the separate "Safety-at-Work" monitor documentation for a descrip-

tion of the codes used for monitor state, OSSD state, device colours and

assignments to OSSDs.

Monitor state

Code significance

0 protective mode, everything OK (output circuits that are not installed, not

configured or dependent output circuits are indicated as OK)

1 protective mode, output circuit 1 off.

2 protective mode, output circuit 2 off

3 protective mode, both output circuits off.

4 configuration mode: power on

5 configuration mode

6 reserved / not defined

7 configuration mode: fatal device error, RESET or device replacement

necessary

Colour coding

Code colour meanining

0 green block is in the ON state (switched on)

1 green flashing block is in the ON state (switched on), but already in the

transition to the OFF state, e.g. shutdown delay

2 yellow block is ready, but is still waiting for a further condition,

e.g. local acknowledgement or Start button

3yellow

flashing

time condition exceeded, action must be repeated, e.g.

synchronization time exceeded

4 red block is in the OFF state (switched off)

5 red flashing the error interlock is active, clear using one the following

actions:

> Acknowledge using the ESC/Service button

> Power OFF/ON

> AS-i OFF/ON

6 grey OSSD not used / no communication with the AS-i slave

1 2 ... 89 90 91 92 93 94 95 96 97 98

Keine Kommentare

Euchner AS-i 3.0 Command Interface Bedienungsanleitung Seite 94