Euchner AS-i 3.0 Command Interface Bedienungsanleitung PDF herunterladen (Seite 46)

AS-i 3.0 Command Interface Commands of the Command Interface

Subject to reasonable modifications due to technical advances Id.-No.: 102875 Issue date - 3.12.2007 EUCHNER GmbH + Co. KG

Kohlhammerstraße 16, D-70771 Leinfelden-Echterdingen Tel. +49/711/7597-0, Fax +49/711/753316

When this command is executed, the AS-i master changes to the offline phase and

then changes back to the normal mode (warm restart).

This command can only be executed in the configuration mode.

Meaning of bit B:

B = 0Single AS-i slave or A-slave

B = 1B-slave

4.5.6 Get extended permanent configuration (GET_PCD)

This call reads the following configuration data (configured data) of an addressed

AS-i slave stored on the EEPROM of the AS-i master:

• I/O configuration

•ID code

• Extended ID1 code

• Extended ID2 code

The configuration data are specified by the manufacturer of the slave.

Request

byte

125

2T – circuit

3 – B slave address

4xID2 xID1

5ID I0

Response

byte

125

2T result

Request

byte

126

2T – circuit

3 – B slave address

Response

byte

126

2T result

3xID2 xID1

4ID I0

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 97 98

Keine Kommentare

Euchner AS-i 3.0 Command Interface Bedienungsanleitung Seite 46