Euchner Electronic-Key Adapter with serial Interface Bedienungsanleitung PDF herunterladen (Seite 11)

Manual EKS Electronic-Key Adapter serial

088796-02-03/05 Subject to technical modifications Page 11/24

5 Mounting

Mounting must be performed only by authorized personnel.

To achieve the degree of protection IP 67, it is necessary to install the Electronic-Key adapter in a

clean, flat metal plate at least 2 mm thick and to tighten the screws to a tightening torque of at least

0.25 Nm.

The Electronic-Key adapter is intended for mounting in control panels with a cut-out measuring

33 mm x 68 mm according to DIN 43700 (see page 8 chapter 4.1 Dimension drawing, Electronic-Key

adapter/front panel cut-out). The device is fastened using screw clamp elements from the rear side of the panel.

The screw clamp elements for front panel mounting are included with the Electronic-Key adapter.

1. Insert Electronic-Key adapter, with seal already bonded in place, into the mounting cut-out from the front.

2. Insert screw clamp elements in the housing of the Electronic-Key adapter and tighten to min. 0.25 Nm.

After mounting, again check the Electronic-Key adapter for firm seating and correct sealing of the front

plate.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Keine Kommentare

Euchner Electronic-Key Adapter with serial Interface Bedienungsanleitung Seite 11