Euchner Electronic-Key Adapter with serial Interface Bedienungsanleitung PDF herunterladen (Seite 8)

Manual EKS Electronic-Key Adapter serial

088796-02-03/05 Subject to technical modifications Page 8/24

4 Technical data

4.1 Dimension drawing, Electronic-Key adapter/front panel cut-out

4.2 Technical data, Electronic-Key adapter

General parameters Value Unit

min. typ. max.

Housing Plastic (PA 6 GF30 gray)

Degree of protection according to EN 60529 IP 67 in mounted condition

Ambient temperature at UB = DC 24 V 0 + 55 °C

Mounting cut-out according to DIN 43700 33 x 68 mm

Connection type for power supply Miniature plug connector 3-pin,

Conductor cross-section max. 1.5 mm²,

tightening torque 0.22 Nm

Operating voltage UB

(regulated, residual ripple < 5 %)

20 24 28 DC V

Current consumption 100 mA

Interface, data transfer

Interface to host control serial RS232 / RS422

(selectable via DIP switch)

Transfer protocol 3964R

Baud rate 9.6 kbaud

Data format 1 start bit, 8 data bits, 1 parity bit (even parity), 1 stop bit

Connection type for serial interface Sub-D 9-pin socket

Cable length RS232 5m

Cable length RS422 1000 m

Active if there is a functional Electronic-Key in the Electronic-

Key adapter (Electronic-Key active).

Out output

Level

Pin 8 Sub-D socket serial interface: RS232

Pin 3 screw terminal power supply: +24 V DC

LED display Green: "Ready" (in operation)

Yellow: "Electronic-Key active" *

* The LED illuminates yellow if there is a functional Electronic-Key in the Electronic-Key adapter.

LED

max. 4mm

1,5 Rubber seal

60,7

70,5

51,5

8,5

DIP switch

Front panel cut-out

according to DIN 43700

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Euchner Electronic-Key Adapter with serial Interface Bedienungsanleitung Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheit Euchner Electronic-Key Adapter with serial Interface