Euchner CES-AZ-UBS-01B (Multicode) Bedienungsanleitung PDF herunterladen (Seite 16)

Operating Instructions Safety System CES-AZ-UBS-01B

System Status Table

Operating mode

Actuator/

Guard position

Safety outputs

13/14 and 23/24

PLC

LED display

Output

State

In- Output

TST

OUT (status signal)

ERR

STATE (green)

OUT (yellow)

ERROR (red)

Normal operation

closed on N 1 0

Normal operation, door closed.

open off N 0 0

Normal operation, door open.

State indication

XoffX00

3 x +

Self-test after operating voltage is applied.

Fault display

XoffN01

Device-internal component failure or

excessively high external interference (EMC).

Test operation

open off 1 0 1

closed off 1 0 1

External device test to “OPEN” and function of ERR output

with door closed.

Key to symbols

N 0 Volt or not connected

1 24 Volt

0 0 Volt

LED is not lit

LED is lit

15 Hz (8 s)

LED ﬂashes for 8 seconds with 15 Hz

3 x +

LED ﬂashes three times and then lights up continuously

3 x

LED ﬂashes three times, and this is then repeated

X Any state

Important!

If you cannot ﬁnd the displayed device status in the system status table, this

indicates that there is an internal device fault. In this case, you should contact

the manufacturer.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

Kommentare zu diesen Handbüchern

Keine Kommentare

Euchner CES-AZ-UBS-01B (Multicode) Bedienungsanleitung Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheit Euchner CES-AZ-UBS-01B (Multicode)